Lectrosonics UM400a Transmitter

$0.00

Quantity available: 2

Description:
The UM400a transmitter combines 100 mW of RF
output with +/-75 kHz wide deviation for extended
operating range and extremely high signal to noise
ratio. These key design features are coupled with the
compandor-free Digital Hybrid Wireless® audio chain
and packaged in the widely recognized Lectrosonics
standard transmitter housing.
The unit is powered by a single 9V battery in the internal compartment, or from external DC using a Lectrosonics ISO9VOLT battery eliminator.

Specs:
Operating frequencies: Block 470: 470.100 – 495.600
Block 19: 486.400 – 511.900
Block 20: 512.000 – 537.500
Block 21. 537.600 – 563.100
Block 22. 563.200 – 588.700
Block 23. 588.800 – 607.90. an. 614.100 – 614.300
Block 24. 614.400 – 639.900
Block 25. 640.000 – 665.500
Block 26. 665.600 – 691.100
Block 27: 691.200 – 716.700 (export only)
Block 28. 716.800 – 742.300 (export only)
Block 29. 742.400 – 767.900 (export only)
Block 944: 944.100 – 951.900
Frequency selection: 256 frequencies in 100kHz steps
RF Power output: 100 mW (nominal)
Pilot tone: 25 to 32 kHz frequency; 5kHz deviation
Frequency stability: ± 0.002%
Deviation: ± 75 kHz (max)
Spurious radiation: 90 dB below carrier
Equivalent input noise: –120 dBV, A-weighted
Input level: Nominal 2 mV to 300 mV, before limiting.
Greater than 1V maximum, with limiting.
Input impedance:
Dynamic mic: 300 Ohms
Electret lavaliere: Input is virtual ground with servo adjusted constant current bias
Line level: 2.7 k Ohms
Input compressor: Dual envelope compressor, >30 dB range
Gain control range: 43 dB; semi-log rotary control
Modulation indicators: Dual bicolor LEDs indicate modulatio. of -20, -10, 0, +10 dB
referenced to full modulation.
Controls: 2 position “OFF-ON” slide switch for noiseless turn on/turn off operation.
Front panel knob adjusts audio gain. Recessed control on side panel adjusts low
frequency rolloff. Rotary switches on side panel adjust transmitter frequency.
Audio Input Jack: Switchcraft 5 pin locking (TA5F)
Antenna: Detachable, flexible wire supplied. 50 Ohm port allows connection to test equipment.
Power Consumption: 80mA
Battery: Precision compartment auto-adjusts to accept any known alkaline 9 Volt battery.
Battery Life: 5 hours (alkaline); 10 hours (lithium)
Operating Temperature: -20 to +140 degrees F
Weight: 6.3 ozs. including battery
Dimensions: 3.1 x 2.4 x .75 inches
Emission Designator. 180KF3E