Lectrosonics HMA C1 Plug on Wireless Microphone Transmitter

$0.00

Quantity available: 1

Description:
This unique plug-on transmitter design will ideally match any microphone or line level source via a standard XLR connector. Phantom power is selectable at 5, 15 and 48 volts, or can be turned off for use with dynamic microphones and line level signal sources.
The design includes a wide tuning range of up to 76 MHz, with tuning steps in increments of 100 kHz or 25 kHz, (19 MHz for block 941 version, for 695 frequencies).
Along with providing peerless audio quality with wide frequency response and dynamic range in Nu Hybrid mode, the technology used in the HMa includes compatibility modes for Lectrosonics Mode 3 and IFB receivers.

Specs:
Operating Frequencies:
Band A1: 470.100 – 537.575
Band B1: 537.600 – 607.950

Frequency Selection Steps: Selectable; 100 kHz or 25 kHz
RF Power output: Selectable 50/100 mW
Pilot tone: 25 to 32 kHz; 3.5 kHz deviation
(in Nu Hybrid mode)
Frequency stability: ± 0.002%
Spurious radiation: Compliant with ETSI EN 300 422-1 v1.4.2
Equivalent input noise: –125 dBV (A-weighted)
Input level: Nominal 2 mV to 300 mV, before limiting.
Greater than 1V maximum, with limiting.
Input impedance: 1K Ohm
Input limiter: Dual envelope “soft” limiter; greater than 30
dB range
Gain control range: 55 dB; panel mounted membrane switches
Modulation indicators: Dual bi-color LEDs indicate modulation of
-20, -10, 0, +10 dB referenced to full
modulation